• Registered: 2013-03-25
  • Posts: 8

Topic: Sending Post-Call results to SOAP web service in per app settings

After I configure the variables to send to my SOAP service for when a call is finished, to post call results, the variables in the QuickFuse GUI vanish upon saving the app, closing, and then re-opening the app Settings.

As a result, QuickFuse sends blanks (self-closed XML elements) to our SOAP service.

My app is setup with two reserved variables.  I have plugged those variables into the M____A app, for example.

Thanks.

  • admin
  • Administrator
  • Offline
  • Registered: 2010-06-15
  • Posts: 661

Re: Sending Post-Call results to SOAP web service in per app settings

Hi,

Thanks for letting us know! We are still tracing the root cause of this bug, we'll update you here on our progress.

Regards,
The QuickFuse Team

  • admin
  • Administrator
  • Offline
  • Registered: 2010-06-15
  • Posts: 661

Re: Sending Post-Call results to SOAP web service in per app settings

Upon further investigation, this is not a bug. The variables you were using in the post-call SOAP had been reserved, but never defined during the call flow. This is, in practice, the same as sending no variable. We're sorry for the misunderstanding.

Regards,
The QuickFuse Team